Recent content by MSoap

Thanks for all of the replies... After looking over the thread again, I realized that I gave the wrong size for the bearing. It is actually a 35mm bore, 80mm OD, and 21mm width. Basically the equivalent size of a 6307 bearing, except that it is a cylindrical roller bearing right now...

The bearing has a ID of 2.25" and an OD of 3", with a width of 0.375" wide.

I was wondering if anybody might have any comments on the possibility of using a cylindrical roller bearing which is completely submerged in a hydraulic oil bath. The bearing will be used on a test stand, where the inside of the bearing housing will have a circulating oil bath, which will be...