Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by mschroeder

  1. mschroeder

    Basic bolt circle diameter dim. Does it control bolt pattern runout to a center?

    Thanks gang-- FYI the 11 degree dim to horizontal was there to tie three sets of smaller bolt circle patterns to each other rotationally and I neglected to omit it for my simplified image. --mschroeder
  2. mschroeder

    Basic bolt circle diameter dim. Does it control bolt pattern runout to a center?

    Here's an image representing the situation. Thanks for the reply. http://files.engineering.com/getfile.aspx?folder=1c72e030-7a75-4177-919a-b90a7356d6e9&file=disk.png
  3. mschroeder

    Basic bolt circle diameter dim. Does it control bolt pattern runout to a center?

    I have a flat disk, 20 holes around, and see so many examples of bolt circle dia's dimensioned as basic with a position on the holes. Does the basic bolt circle dimension control location to a center hole in the disk used as datum A? Does the basic bolt circle diameter dimension still allow...
See more

Part and Inventory Search

Back
Top Bottom