Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by MSarver

  1. MSarver

    ASME Bolt Loads to Torque

    Hello All, My question relates to ASME Section 8 Division 1 Appendix 2 and ASME PCC-1. I'm trying to calculate bolt torque for engineered flanges only and basing my calculations on Appendix 2 to find bolt load, then finding the actual torque value from PCC-1. After finding bolt loads for both...
  2. MSarver

    Spiral Wound Gasket -Proper Seating Width "N" Per ASME VIII Appendix 2

    From my understanding of use with spiral wound gaskets, the inner and outer metallic rings are used as compression stops and should not be used in calculations for proper seating width "N". Which is N=(G_od-G_id)/2 where G_od and G_id are gasket dimensions that are being compressed(touched)...
See more

Part and Inventory Search

Back
Top Bottom