Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by mrf13

  1. mrf13

    Part in a Part; I don't get it...

    Try picking on the two end faces and choose"concentric" as the type of mate. They should line up. If that does not work, then open an assembly document and then bring both parts into that... it is much easier to mate parts this way.
See more

Part and Inventory Search

Back
Top Bottom