Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by mpenney
-
ProE WF4 Dimension shows up in the pdf but not in the drawing
Hi - new here. I am working on a drawing in WF4. When I created a .pdf I noticed that a reference dimension showed up that is obviously incorrect. I went back to the drawing to remove it but it wasn't there. I tried right-clicking over the area and there appears to be nothing at all in that...- mpenney
- Thread
- Replies: 0
- Forum: PTC: Creo Parametric (Pro/ENGINEER)
