Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Mow guy
-
Sizing a 1to1 90 degree gearbox
Thanks for the responses, As I continue looking into this I'm seeing that i might be into far more $ than originally Hoped for. I will try to post as make more conclusions. Thanks again- Mow guy
- Post #5
- Forum: Gear and Pulley engineering
-
Sizing a 1to1 90 degree gearbox
Good morning, I'm just a high school grad with a hobby. I want to connect a gearbox to a hydrostatic wheel motor. This is on a zero turn mower with 37 HP. Engine so the power is split between 2 drive sides and a 61in mower deck. The hydrogear zt4400 pump/motor boasts capabilities of up to 500...- Mow guy
- Thread
- Replies: 4
- Forum: Gear and Pulley engineering
