Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by MORALES68

  1. MORALES68

    set my scale

    hi if any one can give me a tip of how to set my scale 1/8"=1' i start setting my units then i set my drawings limits and star draw and everything is normal into the time i going to plot i uses view ports in paper space when i call for the scale 1/8"=1' my drawing is to small i tray different...
  2. MORALES68

    I CAN'T PUT MY DRAWING SCALE CORECTLY

    One more time tank you for the tips chicopee , IRstuff
  3. MORALES68

    I CAN'T PUT MY DRAWING SCALE CORECTLY

    chicopee i using cad 2005 if this is not the forum where i can go to resolve my problem
  4. MORALES68

    I CAN'T PUT MY DRAWING SCALE CORECTLY

    Tank you for you in formation i am using cad 2005 if you can give me a tip i will really appreciate
  5. MORALES68

    I CAN'T PUT MY DRAWING SCALE CORECTLY

    I SET MY UNITS,MY DRAWING LIMITS AND START DRAWING WHEN I FINISH AND TRAY TO PLOT IN SCALE 1/8"=1' MY DRAWING APPEAR TO SMALL IF ANY TIPS I WILL REALLY APPRECIATE TANK YOU.
  6. MORALES68

    IF THERE IS EASY WAY

    HI,MY QUESTION IS I HAVE FINISH A DRAWING OF IRREGULAR LOT SHAPE MY BUILDING IS INSIDE THE LOT , THE TIES CHANGE FROM ONE SIDE TO THE OTHER MY QUESTION IS IF THERE IS ANY SIMPLE WAY YOU CAN LOCATED THE SPECIFIC POINTS FOR TIES OF THE BUILDING BECAUSE THE WAY I DID I LOCATED ONE POINT OF THE TIES...
See more

Part and Inventory Search

Back
Top Bottom