Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by monopolystar

  1. monopolystar

    advanced simulation

    Hi Tuw, for your information , its a backward extrusion , thus the upper surface of inner surface of inner ring receives the lesser pressure load compared to the bottom surface. Thanks
  2. monopolystar

    advanced simulation

    Hi Tuw, thanks for your kindly replied. Do you mind to have a check on my simulation ? I was trying to apply load in the inner surface of inner ring at the same time with the surface-surface contact force and the bottom corner of inner surface of inner ring should have become from compression...
  3. monopolystar

    advanced simulation

    Hi Tuw, Thanks for your replied once again. I found your file is very useful for me. thank you. In addition , I would like to input different pressure load on the surface of the hole of inner ring instead of applying same pressure load all over the surface. in other words, different nodes on...
  4. monopolystar

    advanced simulation

    Hi Tuw , thank you for your replied. I'm confusing with the result. The inner surface of the outer ring should be having the same force with the outer surface of inner ring. But as you can see from my last post, they are not the same. I wonder what goes wrong. in addition , i would like fixed...
  5. monopolystar

    advanced simulation

    [/URL]] Hi, I face some problem dealing with the setting which shown in the picture above. Which ring should I set to be source region or target region , what does that mean actually ? in addition , about the BCTSET , what do the search distance and coefficient of static friction indicate...
  6. monopolystar

    advanced simulation

    hi tuw , im sincerely appreciate for your replied. It is very helpful ! Thanks a lot.
  7. monopolystar

    advanced simulation

    Hi all , I'm just started using NX 8.5. Recently , Im doing simulation on two ring die. i would like to simulate stress analysis of the surface contact of an inner ring insert into a outer ring. . As you can see from the image, the upper cylinder is the inner ring while the bottom cylinder is...
See more

Part and Inventory Search

Back
Top