I am in the process of obtaining some 304 stainless for weld certification samples. My company calls out ASME SA240 304 STAINLESS on our Weld Procedure Specification. The stainless I received a quote on was listed as ASTM A276, ASTM A479, & QQS-763. Does this mean that I need to obtain different...
I am in the process of obtaining some 304 stainless for weld certification samples. We call out ASME SA240 304 STAINLESS on our Weld Procedure Specification. The stainless I received a quote on was listed as ASTM A276, ASTM A479, & QQS-763. Does this mean that I need to obtain different...
I am working on some WPS documentation. Does a fillet weld fall under the classification of PJP or CJP? Or can a fillet weld be either type? Our WPS calls out fillet weld. Does fillet weld fully explain what is going on or do I need to specify full or partial penetration?
I am using the output of Turck module to power a LED indicator. the output module has an M12 - 3 pin receptacle. I would normally run a single ended cordset assembly from the module and into a water tight enclore. Then i would solder the leads to the LED ass'y. For this application I can not use...
I am using the output of Turck module to power a LED indicator. the output module has an M12 - 3 pin receptacle. I would normally run a single ended cordset assembly from the module and into a water tight enclore. Then i would solder the leads to the LED ass'y. For this application I can not use...
I want to be able to run some simulations of liquid Nitrogen hitting an angled or 3D shaped surface. To make it less complicated, this simulation could assume the liquid as water. I have ACAD, so cosmos is out of the question. Flow 3D is obviously very expensive. Are there any non expensive, or...
We recently used some Vacuum Tubing acquired from Napa in a damping test on one of our dosing units. The material worked great. I did some research and found it to be EPDM type P tubing. I have had no luck in finding out what specific type of EPDM was used in this tubing though. I need some...
We have a carousel that we use to replicate filling lines at beverage plants. Basically it is a 2 foot diameter wheel that holds (14) 20 ounce bottles and rotates at high speeds. We are running tests at high speed ramp up, going from 0 containers per minute to 1,200 cpm in about .75 seconds. The...
We have a carousel that we use to replicate filling lines at beverage plants. Basically it is a 2 foot diameter wheel that holds (14) 20 ounce bottles and rotates at high speeds. We are running tests at high speed ramp up, going from 0 containers per minute to 1,200 cpm in about .75 seconds. The...
My company has nitrogen dosing units. A PLC sends an output to a driver that sends power to a coil. The driver also pulls current away from the coil after a given time duration to allow the coil to close the valve quickly.
We are able to see the 6 millisecond output signal from the PLC to the...
We have nitrogen dosing units. A PLC sends an output to a driver that sends power to a coil. The driver also pulls current away from the coil after a giving time duration to allow the coil to close the valve wuickly.
We are able to see the 6 millisecond output signal from the PLC to the driver...
