I have downloaded several files of tool holders we use. They are .prt files. My question is, how and where do I need to place these files to be read into the Tool library, so I can retrieve them when creating new tools? Any help would be appreciated.
Thanks
Ps. I am using NX 7.5
You should be able to insert the Heidenhain probe cycle into the program. Just insert your cycle def...then a cycle call...you can do right at the machine. Shouldn't be a problem....
Regards
NewCNCist,
First, if I was using a tap, carbide would not be my first choice,
A good quality HSS or Cobalt with TiAn Coating works well. I
would start with a #5 Tap drill, make sure you are drilling deep
enough, to avoid chip packing. I would run that tap at 300 RPM,
which would give you a...
