Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by moiz19670309

  1. moiz19670309

    Safety Class Vs Construction Class

    Under ASME
  2. moiz19670309

    Safety Class Vs Construction Class

    What will be the Nuclear Safety Class of a tool used to handle fuel bundle in Spent Fuel Bay. What will be it's Construction Class
  3. moiz19670309

    Hole size with tolerance for Shaft

    I have a shaft with size dia 260.355 A Shaft sleeve fits over the shaft with rectangular key The sleeve got damaged Now we have to manufacture a new sleeve I am confused what should be the sleeve ID with tolerance that I should give to my machinist. So that the sleeve easily fits on the shaft...
  4. moiz19670309

    SKF Bearing identification

    Thanks All Well we have a Chuck Assembly. When I disassemble it I found this SKF bearing. I noticed that text written on it SKF 51134 M/DH. I searched Google for the full text and was unable to find the meaning of last two alphabet. I downloaded the SKF latest catalogue and search the section...
  5. moiz19670309

    SKF Bearing identification

    Dear I have a SKF bearing having this information. SKF 51134 M/DH Please explain what DH stands for. Thanks
  6. moiz19670309

    Seal Housing Jurisdiction

    As per NB-3411.1, Pump Seal Housing and Seal glands falls under the jurisdiction of ASME. Does this means Mechanical Seals have to be ASME qualified . Hence, Mechanical Seals needs to have qualifications as per ASME requirements. I am totally not clear about application of ASME on Mechanical...
  7. moiz19670309

    Mechanical Seal ASME Jurisdiction

    Please provide some information about. Is Mechanical Seal fall as pressure boundary as per ASME. Or does it's seal faces falls under the pressure boundary limit. I am unable to find explicit answer to this question. Please provide any ASME article reference to clarify.
  8. moiz19670309

    Hello everybody, Questions: 1

  9. moiz19670309

    Hello everybody, Questions: 1

    Sir I am having this problem at my job. I have to use M10 brass bolts. The manual asks a tightening torque of 40 Newton Meter. Is this right torque. I have searched the net for Brass bolt torque chart but not found. Kindly help.
  10. moiz19670309

    Hello everybody, Questions: 1

    Hello everybody, Questions: 1). What is the maximum tightening torque for brass bolts of M10 size ? I want to tighten brass bolts on brass earthing bar. Could you recommend a comprehensive data sheet/table for this purpose ? Thanks.
  11. moiz19670309

    Material Identification

    It is a bolt, composition identified using XRF, surface well prepared, used double precision mode.
  12. moiz19670309

    Material Identification

  13. moiz19670309

    Material Identification

    Any ASTM number for the Alpha Brass. I have to use this material for M10 bolt. The bolt has to be tightened to 40 Newton Meter torque. Any other suggestions for material.
  14. moiz19670309

    Material Identification

    Ni 0.06 Cu 61.44 Zn 38.39 Nb 0.11 Please help me to identify the above material.
  15. moiz19670309

    Shaft and impeller fit

    Dear Geesaman The pump is Boiler Feed Water Pump, vertical type.
See more

Part and Inventory Search

Back
Top