Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by moeykad

  1. moeykad

    clamp/coupling or any locking mechanism recommendation

    Hi Tmoose, Thank you for your response. My apologies for the lack of clarity in my OP. I am adding a picture to my OP, hopefully it gives a better understanding. Please excuse the quality of my collage. In addition, I am more concerned about the connection between chute and valve inlet...
  2. moeykad

    clamp/coupling or any locking mechanism recommendation

    Thank you for your response. Valve will be connected to an actuator (scotch and yoke). By moveable I meant manoeuvrable. Feeder will have two sets of lockable castor wheels. End of the chute won't be a flange so do you think that clamp will be suitable?
  3. moeykad

    clamp/coupling or any locking mechanism recommendation

    I am working on a project that requires a small chute (Length : 240mm) to be installed between a manoeuvrable screw feeder's discharge point and a 6 inch ball valve flange inlet. Any recommendation on easy locking mechanisms b/w the ends of the chute and valve inlet flange and feeder's discharge...
See more

Part and Inventory Search

Back
Top