Is there a simplified formula for hertzian stress and contact area for a pin in a bushing? What makes my problem more complicated is that the loading is not purely radial. I have an offset radial load such that the pin
will theoretically be in point contact on the top of the pin at one end and...
Thank You for the quick and helpful replies to my question, this was my first time using this forum and with this success I will be back. All of the replies are ideas that I hadn't considered. I especially like the idea of the rubber bushing. If anyone has suggestions on vendors, types, etc...
I have an application that pivots no more than 3°, but has a high exposure to dirt and water. The loading is reasonable and almost entirely radial. However, there is some impact loading.
I would normally use a loose fitting hardened steel bushing and grease daily with a lithium based grease...
