Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Mitchel123

  1. Mitchel123

    Display Borders problem in drafting

    I am sure I haven't updated anything.
  2. Mitchel123

    Display Borders problem in drafting

    I have been working on NX7.5 and the model is created from scratch in 7.5. The display border was fine until today, as soon as I open the drafting the border seems large and its large in all 10 sheets of drawings, which has made all the cross sections outside the border as shown in the picture...
  3. Mitchel123

    Display Borders problem in drafting

    HI Guys, In drafting the model display border has increased which also increased the cross section line. I dont want to move the cross section line manually as I have drawing consists of 10 pages. Please suggest if there is any way to make the display borders to its original position. I think...
  4. Mitchel123

    Drafting Detail view Boundary

    Good explanation guys. I completely agree with you both but the fact is that my new Job require me work with layers as they have been using layers from day one and they want me to follow the procedure. I have never used layers before but trying to learn myself. You are right SvenBom. I will be...
  5. Mitchel123

    Drafting Detail view Boundary

    Thank you John and SvenBom. You guys are great. Can you please direct me to any tutorials or forum available to learn working with Layers? I have never worked with layers before. Thank you regards Mitchel
  6. Mitchel123

    Drafting Detail view Boundary

    Thank you John and SvenBom. SvenBom I am unable to see the video properly, the working area is displayed with NX Welcome page. Also John, I think the picture I have attached now can explain clearly what I am looking to do. Although what you have explained in the last video was also pretty...
  7. Mitchel123

    Drafting Detail view Boundary

    NX 8
  8. Mitchel123

    Drafting Detail view Boundary

    Hi, Please see the attached picture. When selecting 'detail view' option in drafting, from the drop down menu the only option available is circular , rectangular by corner etc but if you look at the attached picture the circular 'detail view' was selected but the detail C has no circle and it...
  9. Mitchel123

    Changing Datum in Modelling

    Thank you for your reply guys. John, Using the option 'Align axis to vector' it all goes well when selecting the the arc centres of the 2 holes and also for its fine with 'Specify Vector' and selecting the 'Y' axis of the Coordinate system. When selecting the body gives an error that 'two axes...
  10. Mitchel123

    Changing Datum in Modelling

    Hi Guys, It is going to be a basic question but I never done this before and finding it pretty difficult. Please see the attached model.The model is created using NX 8 I would like to change the datum of the model so that the holes are in vertical position and when I select the 'Top' option...
  11. Mitchel123

    Installing NX 6 in Windows 7

    Sorry Guys didn't reply earlier. I was away. I have contacted GTAC and find out that the file was encrypted therefore I had to re-download and run the set up again. Thank you for your time and input guys. Cheers Mitchel
  12. Mitchel123

    Installing NX 6 in Windows 7

    Hi Guys, I am trying to install NX6 into Windows 7. While installation everything goes well with no problem what so ever. After installation when open NX6, The following application error appear " The application was unable to start correctly (0xc000007b). Click OK to close the application"...
See more

Part and Inventory Search

Back
Top