Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by mincemeat

  1. mincemeat

    Referencing (Xref)

    Let's say c100.dwg is your sheet file ( if you don't like layout tabs). Your Site.dwg file is your base file. You have a survey file Survey.dwg, a Building file from an architect Bldg.dwg, and drawing X.dwg a drawing showing truck turning radii. Your Site.dwg file will have the Survey.dwg and...
  2. mincemeat

    Setting lineweights for dimensions in AutoCAD

    I ran into the same problem and here is what I have found out that works. LWDEFAULT = Default lineweight ex .25mm = 25 DIMLWD = -2(default) DIMLWE = -2(default) Let me know if this works for you. It takes a little bit of playing with, but once it's set I haven't had any problems.
See more

Part and Inventory Search

Back
Top Bottom