Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by miki11
-
Bystronic laser problem on chiller
The problem may be in the bypos itself, one should look to see if it is dirty or maybe the intestines are wrongly turned. Remove the hose from the bypass and measure how many liters of water are flowing per minute.- miki11
- Post #3
- Forum: Laser engineering
-
Bystronic laser
If the error occurs immediately after switching on the resonator: Open the front transformer cover. There is a thermostat in the upper left corner. Remove it, and test with an ometer with heating. I'm not sure, but I think it should switch to 50 degrees. If this happens during operation you have...- miki11
- Post #2
- Forum: Laser engineering
-
Bystronic 4kw laaser cuting problem
Hello, I'm new to the forum, but I've been working on the bystronic laser for a long time. This problem has already been written about but I have not seen a solution to the problem. My 4 kw bystronic laser has reduced power to 2 kw, I had to reduce the cutting speed to get the cut quality. Over...- miki11
- Thread
- Replies: 0
- Forum: Laser engineering
