I'm trying to find the CG of an assembly I built in Pro/E. I manually assigned a volume and mass to each of the assembly components using the edit>setup>mass props function. But when I try calculating the CG of the assembly (using Analysis>Model>Mass Properties) I get a CG that doesn't seem...
I'm trying to find the CG of an assembly I built in Pro/E. I manually assigned a volume and mass to each of the assembly components using the edit>setup>mass props function. But when I try calculating the CG of the assembly (using Analysis>Model>Mass Properties) I get a CG that doesn't seem...
Thanks TVP. I saw those earlier, but was hoping to find a version with the standard Phillips recess. Both NA0068 and NA0089 have the offset cruciform recess. Has anyone seen any metric NAS machine screws with a standard phillips recess?
Does anyone know of any NAS part numbers that cover metric fasteners? Specifically I'm looking for a NAS standard that covers pan head metric machine screws. Thanks for your help.
Does anyone have any experience performing thermal analysis on a PCB in Mechanica? I trying to do some analysis on a 6 layer PCB. I tried modeling and defining each board layer (copper and FR4) in Mechanica, but Pro/E would crash when I tried running an analysis. I then tried modeling the PCB...
Ok. I got figured out how to remove the thread, but the note defining the Tap is still there. I realize that I can hide that part of the note. Really all I'm trying to do is have a smooth drilled hole that has a counter sink. It seems like it required me to chose a Tap, when all I really...
Hello,
I'm trying to figure out a way to make countersunk holes that are not threaded. It seems like the only way Pro E allows you to counter sink holes is if you define the thread size. Do anyone know of a way that I can create a countersink to a plain hole? I would appreciate any help that...
