Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Mike2410
-
cross drilled hole in tube
If the current ANSI 14.5 drawing standard is applied, would a cross drilled hole that extends entirely though a hollow bar (tube) be interpreted correctly with simply a hole size speified or should the hole be specified as 2X? Does ANSI 14.5 clearly state that a break in a cross drilled hole...- Mike2410
- Thread
- Replies: 3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
900# Weld neck flange design
For simplicity,the design can be considered a pipe section with a flange welded on each end. The key issue is the need to machine the faces after welding due to other equipment design considerations. I see the limitations of hubbed flanges in section VIII and it appears to eliminate the weld...- Mike2410
- Post #3
- Forum: Boiler and Pressure Vessel engineering
-
900# Weld neck flange design
I have an application for 6.00" - 900# flanges (3000 psi test pressure) in 2205 Duplex material. I believe I want to specify a full penetration weld for inspection purposes as well as to meet section VIII boiler and pressure flange standards. I plan to machine the flange faces, bolt holes and...- Mike2410
- Thread
- Replies: 8
- Forum: Boiler and Pressure Vessel engineering
