Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Mike Renks

  1. Mike Renks

    Additional Footing Detailing

    Hi Jandra11 To answer your questions, please see below: 1) Typically, you'd want to install mesh/rebar top and bottom, as you're moment could be either negative or positive; depending on the types of loading conditions the footing is under. 2) Yes. You need to use dowels to connect two...
  2. Mike Renks

    Welded cleat/plate supporting other members

    Hi Guys, I'm doing a design/redesign of some cleat plates and currently working through calculating the section capacity in bending. I've stated a couple of assumptions, you can see the snap shot of my situation below. Please advise whether it is OK to assume the plate would bend in double...
See more

Part and Inventory Search

Back
Top