Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by mickdale

  1. mickdale

    weld build up using unassigned to unassigned WPQR

    hello gents i have read through ASME IX and am still at a loss. I have a WPQR GTAW welding an unassigned material to another unassigned material. If i use the same essential and supplemenatry variables to GTAW weld build up one of the unassigned materials used in the WPQR - am i ok to do this...
  2. mickdale

    ASME B31.3 PWHT requirements for P No.5A

    thanks for the help guys
  3. mickdale

    ASME B31.3 PWHT requirements for P No.5A

    ASME B31.3 requirements for heat treatment nominal wall thickness below 13mm. preheat minimum 175 degrees C but PWHT is not required The above requirements are different to those stated in ASME B31.1 which require PWHT 675 - 760 degrees C and ASME VIII which require PWHT 675 degrees C From...
See more

Part and Inventory Search

Back
Top