Recent content by michal77

Many thanks for your replies. Now everything is clear for me.

Hello, I've just studied ISO standard 2768 (Tolerances for linear and angular dimensions without individual tolerance indications). I couldn't find any information about dims taken from the 3D. I wonder if this standard is also applied to dims which can be taken only from 3D or not (dims which...

Hi, I agree with DBezaire. All my friends don't recommend to use hybrid design. Even in some customer enviroments, you don't have a possibility to use it, because it's switched off. best regards Michal77

Hello ImnotfromMars, RPS means - Reference Point System (German way - Referenz Punkt Systematik). It's very useful tool when you have 3D model in position to car line datum. You can indicate on the drawing these 3 points which are very useful for measurement guys. Then they are able to, acc to...

Hi, I cannot find anything about the way of designation of RPS points on the drawing acc. to ASME or ISO. Could you please give me some tip about a standard no. where I can find something about it? I know the customer way, but it's not enough in my case....... thanks in advance Michal77

ajack1, I've tried to find correct way how to indicate, on the drawing, profile of a surface in relation to car line datum. I only found one drawing, where profile of a surface was in relation to X,Y,Z. For me this indication is clear and it looks OK, but I'm not sure what standard states in...

ajack1 - my glass shape is in a 'car position' so on second thought, I'm going to use a carline master datum as you said. One thing which should be done, is to establish on the drawing the RPS points and points which should be measured on my 'red area'. Then I will put a table with coordinates...

ewh, Last question from my side, please don't get nervous :) You stated: ....the irregular surface datum is itself related back to the three primary datum. Unfortunately it's little unclear for me...Is it mean that this surface is established in correct position in 3D and it's in relation to...

Now should be fine.... http://files.engineering.com/getfile.aspx?folder=4ad270f3-2d02-40b6-a3af-f7a6dd4d6246&file=10.jpg

Thanks a lot for your support. I would like to show you, why I need an irregular shape as a datum. On attached file you can see simplification of a glass shape which is completely irregular (don't take into consideration the borders, they are not important). You can measure only openings for...

I wonder if it is possible to refer profile of a surface to a datum which is an irregular shape. Please take a look on attached example. Let say that drawing is acc. to ASME (but in this case I'm not sure that there is a difference between ISO and ASME). Many thanks for any remarks. michal 77

magicmurali, I suggest to delete this angle constrain and then use 3D compass on selected part in the assy.Pressed shift button will allow you to move parts only with respect to constrains. To make movie just use - Tools/Image/Video. I hope it will help.

Hi Brandy7, In both cases you are right, it was done by accident. I was so concentrated on position tolerance of the opening, that I missed this....

Y14.100 series sounds interesting, I'll check out this.... I've been once in UK during my business trip, very interesting country. I'm going to create a new post, because there is still some questions which should be figured out by me, so I hope we'll be in touch. Best regards Michal PS -...

Thanks KENAT:) Normally in Poland we use ISO standard, but sometimes like for example in my case, we make drawings according to ASME. I assume that it depends on country from which company is. My automotive company is from Canada, so it's probably a reason of my adventure with ASME. Hmmmmm I...