Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Mhanley

  1. Mhanley

    Heat Exchanger Design

    Hello I have been tasked with designing a heat exchanger for a heated platen press but have very limited knowledge of the subject. Here is what I have defined: REQUIREMENTS: CAN'T COOL FASTER THAN 5°F/MIN MOLD TEMP AT COOLEST WILL BE 150°F IN BETWEEN CYCLES CAN'T COOL SLOWER THAN 0.5°F/MIN...
See more

Part and Inventory Search

Back
Top Bottom