Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by meridian5850
-
Defining tangency with GD&T?
I have a solid cylindrical part with a diameter of .375" and a SR.275" at one end with a blend radius of SR.050" between the dia. and spherical radius. The SR.275 and SR.050 blend radius must be tangent, but we cannot figure out how to specify this with GD&T without having an unreasonable...- meridian5850
- Thread
- Replies: 4
- Forum: Drafting Standards, GD&T & Tolerance Analysis
