Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Medan Ovidiu
-
Machining burrs - any standard?
Thanks you Ryan!!![bow]- Medan Ovidiu
- Post #3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Machining burrs - any standard?
Hello guys, I have this tipe off part: The specification is say "part to be free from machining burrs" On the drawing there is no any specification to be chamfren but our suplayer make a chamfer. Final customer dont accept this chamfer on the part because is not mentioned on the 2D drawing...- Medan Ovidiu
- Thread
- Replies: 4
- Forum: Drafting Standards, GD&T & Tolerance Analysis
