Wow, that's slick! Thanks much...
I can't have the drag created by the wave washer, but it looks like it's not needed for assembly. Even if it were, a slotted or 2-piece shim could be used and removed after assembly.
Do you have personal experience with these? How do you like them?
Thx again.
Hi all,
I have an assembly of serial four bar linkages designed, but am looking for different options on implementing the joints, which I need to be relatively low-profile.
General info: The loads are very small, with linkage lengths 0.625-3.000" and widths 0.250"-ish. Linkages are made of...
