Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by MechEng8246
-
Rapid Prototyping
Hi Everybody, I was just wondering whether it's possible to use thermosetting plastic (epoxy for example) as a base material for rapid prototyping. If it's possible, then how are you going to deal with the curing process of the thermoset? Thank you for your replies!- MechEng8246
- Thread
- Replies: 4
- Forum: Mechanical engineering general discussion
