Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by MechEng275
-
Hex Standoff inserted into baseplate thread failure
looking for help on how to conduct an analysis with the following scenario: A 0.25in thick vertical aluminum baseplate (plate a) has 4x tapped thru all #6 holes of spaced out in a rectangle pattern with dimensions of 4.5in width 3.5in height. Each one of these tapped holes has a hex standoff...- MechEng275
- Thread
- Replies: 1
- Forum: Mechanical engineering general discussion
