Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by mechanik1208

  1. mechanik1208

    ansys parametric scripting help

    Hello, I want to write a parametric script for ansys in python. I am new to Ansys, but have programming experience. I need some instructions as to where i can start. Ansys scripting manual is one. I have found out that Workbench is the only place (other being cmd) from where i can run my .py...
  2. mechanik1208

    reaction forces delay

    Hello, I am trying an impact of rigid body with a deformable body. I defined a ref. point for the rigid body and applied the displacement. There are 2 steps in my case. step 1 : It brings the rigid body in contact with the deformable body (just touching and no further propagation to step 2)...
  3. mechanik1208

    Reaction Forces from enforced displacments

    Hello, Thank you for the explanation. Its been very useful. Regards, mechanik
  4. mechanik1208

    Reaction Forces from enforced displacments

    Hello, I would appreciate a constructive advice rather than sarcasm. Please forgive my ignorance, but i hope you understood the problem that i was trying to state. Even with a simple cantilever model, first you give enforced displacement, then calculate strain and reaction force. Now, if...
  5. mechanik1208

    Reaction Forces from enforced displacments

    Hello, Thanks for the quick reply. I would like to address the following things. 1) I tried to generalize my problem in nx. So i took a simple cantilever beam and applied enforced displacement. The reaction forces do not match the deflection force(which i applied in the next simulation to...
  6. mechanik1208

    Reaction Forces from enforced displacments

    Hello, I have similar problem with a 3D model in NX 8.0. I have used tetrahedral elements for a plastic isotropic assigned material. The enforced displacement doesn't give the exact reaction force and in another simulation the load constraint doesn't match the applied force result. My...
See more

Part and Inventory Search

Back
Top