Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by MecEngSelli

  1. MecEngSelli

    Heat Exchanger design problem

    I will try that thanks Afox88
  2. MecEngSelli

    Heat Exchanger design problem

    Good morning Everyone. I'm developing and evaporator with Ø2580mm and 1760 tubes of 15.000mm, it is vertical and the materials of the head and tubes are AISI 316 and the shell is ASTM A 285 Gr C So when i run the calculation it appears the following message. ASME: Shell side MAWP 0,14 kPa <...
  3. MecEngSelli

    Appendix 2-6 for COMPRESS

    Good morning, I designed a flange where the bolt's exceed the spacing of 2db + t, in this case, following Apendix 2-6 i need to apply equation 7. Where can i find this option in Compress? Thank you!
  4. MecEngSelli

    ASME Flange Fabrication

    Ahh, now i got it! Thanks!
  5. MecEngSelli

    ASME Flange Fabrication

    SnTMan this is the image, english is not my mother tongue, so i do not know how to spell the word to fabricate a flange in the methode as stated in the image above, The near 600mm was supposed to mean a 24" flange for a manway, And by building it from plate, was because of lack of time to buy...
  6. MecEngSelli

    ASME Flange Fabrication

    Good morning, I need to fabricate some ASME Flanges B 16.5 and i can't find where in the ASME code it says if i can build from a whole plate (one single disc) or if i can fabricate with crankshaft method. The diameter i must build is something near Ø600mm Can anyone help me point the area...
See more

Part and Inventory Search

Back
Top