Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by MeasureThis
-
Basic dims
Our company is diving into GD&T once again. We took an online course but it didn't cover what I am asking. Many sites I've been looking up state a drawing is not done if the basic dimension is not toleranced. Either by note or from a feature control frame on the feature it is referencing. We are...- MeasureThis
- Thread
- Replies: 1
- Forum: ANSI (standards) Code Issues
