Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by measure

  1. measure

    Adhesive anchors for large loads?

    IJR, Some of these epoxy anchors are not recommended for "hot" environments. The connection may be critical in a fire. Regards, Measure
  2. measure

    ASCE 7-98 Allowable Stress Increase

    See Sections 2.4.1, 2.4.2 Basic Combinations, and 2.4.3 Load Reductions. I hope this helps
  3. measure

    Increasing Beam Capacity

    Good discussion. In similar situations I have used wide flange sections to reinforce the bottom of existing beams because they can be positioned and clamped in place before welding. A flat plate would be first choice if the required increase is small. I have never had to reinforce the entire...
See more

Part and Inventory Search

Back
Top Bottom