Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by mdmiller2000

  1. mdmiller2000

    Plate Bending

    The point where the 10Klbs is applied is a 3/4 bolt that is threaded into a 10klb Load Cell that measures the force applied. The load cell its self is about a 6" diameter and about 1.5" thick and is secured in 6 places with smaller bolts. This might make thing more complicated or easier.
  2. mdmiller2000

    Plate Bending

    Thank you very much. I understand I am looking at the stress of the plate. Where can I look up the stress per thickness of plate?
  3. mdmiller2000

    Plate Bending

    I have attached a sketch of my application. I am trying to figure out how thin i can make the 2" plate in order to put the 10K pounds of force on the plate. There is no reason I cannot use gussets on top if that will help. The whole structure will be sitting on a platform (not suspended). I...

Part and Inventory Search

Back
Top