Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by mcmg

  1. mcmg

    Flare inspection

    Hi, Actually, what is connected to the cold flare are PVs for two cryogenic tanks, although, the BOG compressors are working during this time, hence based on data, the demand for the PVs on these tanks connected to the cold flare is very small. On the hot flare, aside from fire case PSVs...
  2. mcmg

    Flare inspection

    Hi all, We have two flare system, hot and cold. The flare tips are stacked side by side, approximately ~0.4 to 0.5m difference, center to center. The plan is to turn off the hot flare as the hot KO drum is intended to be inspected. The cold flare is still, however, in service as we have some...
  3. mcmg

    Vacuum in gravity flow

    Thanks to your replies. @itdepends: im still confused with #3. the difference in velocities between the flows at high and low temperature is just about 10%.. is there like an equation that may be used to check this? @littleinch: i think the tank is not suited to handle high pressures (will...
  4. mcmg

    Vacuum in gravity flow

    Hi. I've read a lot of valuable information regarding this topic on this forum, but I am still quite bothered with the problem I am currently handling. Hope you can all help me. Posted this topic too on cheresources. The scenario is: A closed loop system with 46wt% water and 54wt% ethylene...
See more

Part and Inventory Search

Back
Top