Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by MCM
-
PLASTIC GEAR DESIGN
June, try these site: - moldedgear.com - www.agma.org- MCM
- Post #4
- Forum: Gear and Pulley engineering
-
Drive system design question
Hi. I think belt drive(pulley) has some advantages over gear drive for your system, for instance it produces less noise, less expensive, easier to maintain, easier to assemble etc.- MCM
- Post #2
- Forum: Gear and Pulley engineering
-
I Need any information you have please !!??
Hi Bader, Try this site: www.leser.com . They are the manufacturer of Relief Valve. Download their full catalogue, you will find lots of useful info in it. Regards MCM- MCM
- Post #5
- Forum: Valve engineering
-
Bronze Bushing Design
By taking several dimensions at several points on the existing bushings, the smallest diameter or the smallest clearance found must be the design clearance. This is true if no heavy vibrations detected. The running clearances also depend on the operating enviroment. If foreign particles, e.g...- MCM
- Post #10
- Forum: Gear and Pulley engineering
-
30 Shore '00' materials
Anybody tried Sorbothane? Slightly tacky, very soft, and a variety of durometers. Unfortunately it's propritary with high MOQ's.- MCM
- Post #8
- Forum: Rubber engineering
