Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by MAUREENGLEASON
-
-
FULL PENETRATION WELDS
We are fabricating .5 inch astm a-53 b steel pipe (maximum 50PSI.) Applicable code either aws d1.1 or asme section 9. Customer doesn't want us to use GMAW-S unless we can pass UT testing; we were off by .001 inch and failed; is there any tolerance?- MAUREENGLEASON
- Post #3
- Forum: AWS (welding) Code Issues
-
FULL PENETRATION WELDS
are there allowable tolerances when doing full penetration welds- MAUREENGLEASON
- Thread
- Replies: 9
- Forum: AWS (welding) Code Issues
