Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by MattJackson
-
Relationship between pressure and flow is to achieve the optimum heat loss?
Hello All, Please see attached a 3D image of the chiller set-up. The chiller is fed with air at ambiant temperature at a rate of 7.06 m^3/hr at 100 psi into the inlet and through the steel chiller. The chiller that is manufactured from steel is used to cool the casting (steel) more quickly on...- MattJackson
- Post #6
- Forum: Heat Transfer & Thermodynamics engineering
-
Relationship between pressure and flow is to achieve the optimum heat loss?
Many thanks everyone. Zekeman i will post an image etc. when i have one. rmw thanks, i did think it was something like that but wasnt sure. I'm guessing the LMTD is the log mean temp. difference? Is that something to do with the natural logs of the radius ratio's in the pipe etc? Thanks.- MattJackson
- Post #5
- Forum: Heat Transfer & Thermodynamics engineering
-
Relationship between pressure and flow is to achieve the optimum heat loss?
Hello All, I have been asked to look into artificially cool a steel ‘chill’ within a sand mould. The chill by nature conducts heat out of the liquid casting aiding direction solidification. I have been asked to look into maintaining/prolonging the thermal differential between the chill and...- MattJackson
- Thread
- Replies: 6
- Forum: Heat Transfer & Thermodynamics engineering
