Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by mattc80

  1. mattc80

    calculating pressures in split flow from a compressor

    Hi, I have an NPK09 24v DC air compressor attached to which I have 4mm inner diameter tubing split into 3 then these tubes are split into 3 again leaving 9 4mm inner diameter outlet tubes (see diagram). I wish to calculate the theoretical mass flow rates, exit pressures and hence force exerted...
  2. mattc80

    problems with 'subtract' function

    I am trying to subtract the volume of an upper jaw from an extruded block. However whenever I try this, the finished block just has an outline drawing of the extracted shape but it hasn't physically removed this volume from the block (pictured attached). I have tried using the subtract function...
  3. mattc80

    pneumatic circuit design

    Hi, I need to design a pneumatic system which has 12 outlet tubes split into 3 independent groups of 4 tubes. I need to control each group to either suck or blow air through the 4 tubes. I will be using venturi valves, solenoid valves and a 6 bar air supply. I hope to control the solenoid...
See more

Part and Inventory Search

Back
Top