Recent content by MatEngTED

Do you know where I can find a Continuous Cooling Transformation (CCT) Diagram for 440C Stainless Steel? Thanks.

I went to a local university yesterday and looked in the Atlas of Time Temperature Diagrams for Irons and Steels but it did not have 440C listed.

I need a TTT diagram for 440C martensitic stainless steel. Do you know where I can find it? Thanks!

I am having a difficult time finding a source for SAE 10B22 round, any suggestions would be greatly appreciated.

Need to know what weld wire to use for AMS # 4214H, UNS # AO3550, Alloy 355.0-T6 Aluminum Casting. Please advise. Thanks.

Need information on welding ASTM A-108 1213-1215. It is screw machine stock and the only information found to date is that it is not considered weldable because of the high sulfur content. Background information: Thickest joint member is 3/8". Welding process that needs to be used is GMAW or...

Need to know how to get specs as well as suppliers for Corning code #0120 and #0010. Also, is there a manufacturer of EMGO 360 glass in the US?

The phenolic acts as a crosslinking agent.

Need to locate supplier source(s) for polyvinyl butyral (PVB) phenolic film. Any recommendations appreciated.

Looking for a polymer to extrude over a metal coil. Material must be gamma sterilizable to 90 kGy, Coil is approximately 10 ft. long and 0.1 in. in diameter. Material must be low cost.

Need general information on bonding quartz to quartz. The application must hold at 850C.

Austentic SS is not necessary but we would like to keep cost down. No lubrication used.

Mostly water with trace H2S and CO2

What kind of factor will a velocity of 300ft/sec have on the wear rate of 316 Stainless Steel? If (and why) 316 is not recommended, what castable alloy would be recommended?

Would the graphite provide the 50 to 100+ cycle life?