Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Mary rs

  1. Mary rs

    help needed regarding fixing and moving objects in different steps

    Rods are being displaced with an axial connector. Since I had to fix this little soon so I asked for help. Thanks for your help and suggestion. I will learn and fix the issue.
  2. Mary rs

    help needed regarding fixing and moving objects in different steps

    Hi Mustaine3, I am sorry that it was not clear. I could not attach the input file so I have attached a sketch here. I hope this will make you easier to understand. I think the issue is with the local coordinate system. I am not very sure on what coordinate system should I use when I assign...
  3. Mary rs

    help needed regarding fixing and moving objects in different steps

    Hi Mustaine3, I am talking about relative movement. In step 1, I want both the objects and the box to be fixed. In step 2, I want both the objects to move along U1 (with connector displacement) and the box to be fixed. I could solve the question that I asked previously. In step 1, I applied...
  4. Mary rs

    Transform coordinate system

    In preprocessing
  5. Mary rs

    Transform coordinate system

    Hi, I have a little confusion on applying transform coordinate system for particular node sets. Can anyone give idea on how to select the required transform coordinate system for a particular node set? Thank you.
  6. Mary rs

    help needed regarding fixing and moving objects in different steps

    Hi, I need to fix two objects in a step and let those move in next step along U1. These two objects are connected by an axial connector. Most part of them are enclosed with a box and are coupled. The objects and the box should be fixed in a way that entire objects and the box do not move in...
  7. Mary rs

    tethering simulation

    Hi IceBreakerSours, Thank you so much for your suggestion. Since I am very new to abaqus, I have a lot to know. For now, I am trying to figure out on how to start and then carry on my work. If I get into some issues, I will try to ask my question in specific way so that everybody could...
  8. Mary rs

    tethering simulation

    Hi, I want to apply compression force on the convexity curve of spine while allowing the concavity growth? How can I simulate this tethering procedure? Any help or ideas would be highly appreciated. Thanks.
  9. Mary rs

    terminate Abaqus job

    Thank you Mustaine3. I killed the job in the OS.
  10. Mary rs

    terminate Abaqus job

    Hi, I am having trouble to terminate my Abaqus job. When I try to delete the 023 file, it says- The action can't be completed because the file is open in SMAStandard. I had already killed the job and tried to terminate through command as well but the file is still there. And looks like the job...
See more

Part and Inventory Search

Back
Top