Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by MartinUsher

  1. MartinUsher

    hole mapping

    understood, but i am looking for a more accurate and quicker method, something an operator can do on the fly with the drill at cut, or in a retract position say .025" of the cut face. using a phased array in two positions could work but i am not that familiar with the operation. two single point...
  2. MartinUsher

    hole mapping

    As the title says, i have a project where i need to drill a small hole (.25") offcentre in a diameter bar approx 40" deep. mapping this hole has given me a few headaches, using ultrasound i can only find the hole and its proximity to the wall or outside diameter, single axis only. what id like...

Part and Inventory Search

Back
Top