Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by marklale
-
Question on NX 7.5/8.5 Screw Clearance Holes - which standards were used to generate the tables?
Being a ex-toolmaker, I can tell you that there are standard c,bore tools that come in 1/64 and 1/32 over size. In the day drawings standards were such that a hole call out was drill and c'bore for a certain size hole. We did not know of any engineering standards. This may have come out of the...- marklale
- Post #14
- Forum: Siemens: UG/NX
