Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by MarcusJonker
-
cutting or drilling in a NX assemby with an array
That is correct PrintScaffold, I use a component arrays of mostly standard items (blocks of foam, beams of tree, more or less like LEGO :) ) Anyone any ideas? It seemed straightforward to cut an hole in an array of blocks but it looks like that NX is not that dynamic without some extra...- MarcusJonker
- Post #5
- Forum: Siemens: UG/NX
-
cutting or drilling in a NX assemby with an array
thanks schellenbergj I may misunderstand this selection rule, do you mean selection filter? I normally use Entire assembly, but I tried the 'workpart and components' selection for the assembly cut, but no luck... the pocket will not continue in the new blocks of the array. [sad] In the filter...- MarcusJonker
- Post #3
- Forum: Siemens: UG/NX
-
cutting or drilling in a NX assemby with an array
Hey I work with cad models that are configurable with expressions (some basic like length and width, others a bit more complex but following the same principle) The thing is that inside the assembly I have an array of building blocks in which I in the end want to drill some holes or cut some...- MarcusJonker
- Thread
- Replies: 4
- Forum: Siemens: UG/NX
