Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Maneng
-
Allowable Stresses for HK 40
metengr, MJCronin & ijezer, Many thanks for your response. I had done some survey on internet prior to posting this question. API 530 does provide allowable stresses above 1400F. I am looking for the allowable stress values from 70F to 1400F. If you are aware of the source where I can get...- Maneng
- Post #5
- Forum: Boiler and Pressure Vessel engineering
-
Allowable Stresses for HK 40
I am looking for Allowable Stress Values (below and in rupture / creep range) for A 351 HK 40 castings used for supports in fired heaters. Would appreciate if you can provide some reference. Thanks- Maneng
- Thread
- Replies: 5
- Forum: Boiler and Pressure Vessel engineering
