Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by mal78ibu
-
Tank Vent Orifice Plate
Need some thoughts as to go about the calculations. I have a tank of NH3 padded with N2 to 140 psig that I want to vent down to a recovery system, but I want to restrict the flow to 50 scfm during the vent down. I am planning on using 1" pipe but will need an orifice to restrict the flow so...- mal78ibu
- Thread
- Replies: 3
- Forum: Chemical process engineering
