Recent content by MakeItGuy

Thanks so much. Will check that out.

Seeking a single component material requiring low heat (110 c) to become pliable, for low pressure injection of small flexible components. The injection heat would initiate activation, creating a higher melt temperature (150 c+) once parts cool. Similar to hot-glue being injected, but higher...

Seeking a single component material requiring low heat (110 c) to become pliable, for low pressure injection of small flexible components. The injection heat would initiate activation, creating a higher melt temperature (150 c+) once parts cool. Similar to hot-glue being injected, but higher...