Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by majkicrs

  1. majkicrs

    Bystronic 3015 lost cnc 90 software

    Hello, I have problem with bystronic laser 3015, last week electricity power went out few times and after that cnc 90 software cant start anymore. I doubt that maybe memory on one card in the computer on which is instaled software is cleared after that electricity problem. That is special card...
  2. majkicrs

    Bystronic bystar 3015 power problem

    At 100% it shows about 80 on the current, but i have noticed when power go over 80% power the current are not stable, and goes a bit up and down.. We have checked gases and its ok, turbo was changed about 8 years ago and installed new one, its ok. Water flow is 80 We didnt check voltage at the...
  3. majkicrs

    Bystronic bystar 3015 power problem

    hello, i have problem with bystar 3015. When we cutting at 100% power the power at small display write only 1350W istead of 2800w. We can not cut thicker material of 5mm.I have checked high voltage lamps and its all ok.Check all mirrors and it seems to be ok. Does anyone can help?
See more

Part and Inventory Search

Back
Top