Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by magesh2010

  1. magesh2010

    API 650 Construction

    Thanks JStephen, Is out-of plumb tolerance is worked out for each course? ie say if the bottom course is 2400 heigh, it should be with in +/- 12mm (2400/200) or it is only measured at overall tank height?
  2. magesh2010

    API 650 Construction

    Hi All I am just wondering where to measure the radius of each course and how the tolernce applies to tank contruction as per API. (API indicates the measure the radius of bottom course 0.3 mtr from base, but not sure about the other courses) Please advise
See more

Part and Inventory Search

Back
Top Bottom