Recent content by madsd

Hello again, i was looking at the new standard and it turns out that if you use the old standard DIN 5480-14, it's much easier to find

I have the standard in front of me right now and either I have gone blind or looked at it too long, but I can't find the calculations. Can anyone tell SPECIFICALLY how to calculate the tolerances. But thanks to dinjin and spigor for the speedy replies.

Yes thank you, I know how to calculate the pin size and the measure between them. I just don't know how to specify the correct tolerance.

Hello, I don't need if this has been answered before, but can you please tell how to calculate the min and max measurements, when you measure between to pins/balls? I have DIN 5480, parts 1, 2 and 15. In DIN 5480-2, I can find the nominal value in the tables, when you are measuring between 2...