Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by MadMike08
-
NA Miniature metric fastener question
The fasteners are purchased to the NA spec. (NA0069-020006. I had assumed that the nominal length was the maximum, but I wanted to confirm that. As far as the minimum length is concerned, I've not seen it specified. I have a situation where no tolerance analysis was evidently performed...- MadMike08
- Post #4
- Forum: Mechanical engineering general discussion
-
NA Miniature metric fastener question
For some reason I cannot find actual fastener dimensions and tolerances for miniature metric fasteners. I have a fit probelmn with miniature components, where a few thousandths makes a difference. How do I find the tolerance for the threaded length of a mini metric fastener? It's an M2 x 6mm...- MadMike08
- Thread
- Replies: 4
- Forum: Mechanical engineering general discussion
