Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by MaddMaxx
-
Tolerancing Dispute
Thank you very much. That's what I thought but was not sure.- MaddMaxx
- Post #3
- Forum: ANSI (standards) Code Issues
-
Tolerancing Dispute
Can someone help me resolve an issue. When I use limits tolerancing, where it shows both an upper and lower dimension that a part can be made to, I'm used to showing the upper dimension above the lower. I'm now told that is incorrect and it should be reversed, showing the lower on top. Is...- MaddMaxx
- Thread
- Replies: 13
- Forum: ANSI (standards) Code Issues
